|
 Vacuum
Cups and Suction Cups
Vacuum Cup
Fittings - Group 3
Fittings which Push-In
from the Bottom
for ANVER Group 3 Universal Suction Cups
View Printer-Friendly PDF Page
|
|
-
ANVER
divides small universal vacuum suction cup fittings into three groups based on
mounting specifications and style. The Group 3 Fittings shown here are
those that push in from the bottom, exposing a male thread at the top of
the cup. -
Within each vacuum fitting group, the
hardware is interchangeable with all other cups within the group. Any
Group 3 fitting will fit any Group 3 cup. -
These all-metal, electro-less
nickel-plated brass fittings are reusable. Once you buy the cups with
fittings you only need to buy replacement rubber cups
in the future.
-
The cup is held from the bottom flange
of the fitting which is screwed into a female connection above the cup
to hold it tight. Replacement takes only a few seconds and requires that
you unscrew the fitting, replace the cup, and screw the fitting back on. You can usually do this by hand, by grasping the rubber cup and fitting,
and turning. However, should you desire, you can also use a screw driver
from below the cup.
-
These specific cup fittings are top
quality, production grade fittings made by
ANVER Corp in the USA.
|
Group 3 Vacuum Cup
Fittings:
 |
The "G" thread is
also known as BSPP, commonly used world-wide for
Vacuum Applications. |
Other Adapter Fittings for
Other Connections:
Female-to-Female
Adapters |
Female-to-Male
Adapters |
Male-to-Male
Adapters |
Group 1 Vacuum
Cup Fittings |
Group 2 Vacuum
Cup Fittings |
 |
 |
 |
 |
 |
Group
3 Fitting Washer Specifications:
 |
For
Information on how to build ANVER Valve Cup Assemblies
using select Group 3 Fittings with ANVER Flat Cups F77, F85 and F95,
 Click Here. |
Vacuum Cups
that Use Group 3 Vacuum Fittings:
|
