Vacuum Cups and
1.5 Bellows Vacuum Cups and Suction Cups
Vacuum Cup Materials:
standard materials are Neoprene (NEO) and Silicone (SIT).
For more information on the
materials, Click Here.
Ideal for use where
level compensation is desired on an irregularly shaped object, where a vertical
offset motion is involved, for use on curved surfaces, or for separating thin
work pieces. Available in sizes from 0.40 to 6.10 inches (11 to
NOTE: Click on any of the the small thumbnail photos in this chart to
enlarge for more detail and specifications.
(Click to Enlarge)
and Part No.
(Click Image for
Fitting UNF Male is a 10-32 UNF Male fitting. It allows you to
screw directly into any of the SLSA-1
Suspensions. Fits all the same cups as the 10-15 Fitting above, but in
a 10-32 UNF version. Comes with captured O-ring for a vacuum tight seal. Popular alternate fitting for
the North American market.
Fitting 1/2" with
1/2" female center port connection with optional NPSF 1/8"
female port often used as a blow-off port. (G 1/8" female)
All cups shown above are identical in size and shape to P-Brand's cups. The
represent the cup
dimensions without a load as given by P-Series. The 'compressed' column
specifications are important in making sure that everything fits, and represent
the actual size of the cup after full compression (being flattened out) on a
level load. (This difference is negligible in the F series.) The bigger the cup
the greater the enlargement of the diameter. A lower
vacuum level will lessen this compression (or flattening out); however, make
sure to leave enough room for the static height of the cup in your design.
The "G" thread is also
known as BSPP, commonly used world-wide for Vacuum