Vacuum Cups and Suction Cups
Vacuum Cup Fittings - Group 2
Fittings which Push-In from the Bottom for ANVER Group 2 Universal Suction Cups

• ANVER divides small universal vacuum suction cups into three groups based on mounting specifications and style. The Group Two Fittings shown here are those that push in from the bottom, exposing a male thread at the top of the cup.
• Within each vacuum fitting group, the hardware is interchangeable with all other cups within the group. Any Group 2 fitting will fit any Group 2 cup. 
• These all-metal, electro-less nickel-plated brass fittings are reusable. Once you buy the cups with fittings you only need to buy replacement rubber cups in the future.
• The cup is held from the bottom flange of the fitting which is screwed into a female connection above the cup to hold it tight. Replacement takes only a few seconds and requires that you unscrew the fitting, replace the cup, and screw the fitting back on. You can usually do this by hand, by grasping the rubber cup and fitting, and turning. However, should you desire, you can also use a screw driver from below the cup. 
• These specific cup fittings are top quality, production grade fittings made by ANVER Corp. in the USA.

Vacuum Fitting
Part No.

Thru Hole Dia.
or Thread
in.
(mm)

H
Height
in.
(mm)

The HS5 fitting screws into the SLSA-1 Suspensions without a top nut

HS5

0.11
(2.7)

0.71
(18)

The HS10-32 fitting screws into any HS1032-1032F fitting or mounting (also screws into M5 female)

HS10-32

0.10
(2.5)

0.71
(18)

The HS6 fitting screws into any HS6 fitting or mounting

HS6

0.14
(3.5)

0.79
(20)

The HS8 fitting screws into any 8 mm female fitting or mounting

HS8

0.20
(5.1)

0.79
(20)

F30-, F35-, F40-, F52-, F60-

B1.5-33-, B1.5-43-, B1.5-53-, B1.5-63

B2.5-32-, B2.5-42-, B2.5-62

ANVER Corp.,  36 Parmenter Rd,  Hudson, MA  01749  USA  -  Tel: 800-654-3500  -  +1-978-568-0221  -  Fax: +1-978-568-1570

Copyright © ANVER Corp. 2012

Terms of use