Vacuum Generators and Vacuum Stations
Self-Contained Electric Vacuum Stations
VPE3 Series with ANVER VacGuard II™ Vacuum Control System

Safety Features:

• VacGuard IVacuum Control System
  VacGuard Vacuum Control System This revolutionary solid-state Vacuum Control System combines all the required vacuum generator controls in a rugged, compact polycarbonate enclosure. The VacGuard controls all vacuum pump functions, safety warning lights and a standard VLS-03E audible vacuum leakage warning system.

• Front Control Panel and Gauges
  All gauges, lights and power switches are mounted on the front of the control panel. The two vacuum gauges on the face of the panel display the level of vacuum in the manifold and in the reservoir. The control pendant clip mounts to the front handle on a 10 ft. coiled cord and provides rapid attach and release functions at the operator’s fingertips.

• Indicator Lights
  Green light indicates, “safe” vacuum level. Red light indicates, “unsafe” vacuum level.

• Vacuum Retention
  The system includes an internal check valve to stop loss of vacuum in the event of a power failure (non-porous loads). A 3.5 gallon (822 cu. in.) vacuum reservoir assists in maintaining a safe vacuum level during a power failure (non-porous loads).

• Thermal Overload Protection
  Heat damage is prevented by a thermal sensor that shuts off the motor if the motor temperature exceeds safe limits.

• Ergonomic Adjustable Front Handlebar
  Easy to grasp, large loop handlebar enables the operator to easily and safely maneuver the attached load without touching the load itself. Handlebar can be adjusted for smaller size loads.

• Attach and Release Control Pendant
  Provided with attach and release switch with safety interlock pushbutton and 10 ft. coil cord.

• Twist-Lock Power Cord Connectors
  The Twist-lock receptacles, both the male and female are supplied, which helps prevent accidental disconnection from the power source.

• VLS-03E Audible Vacuum Leakage Sensor Warning System (Standard)
  Integrated Electronically controlled vacuum leakage sensor monitors vacuum level and will sound an alarm if a slow vacuum leak is present when vacuum level drops to a pre-determined set-point.

Maintenance:

• Bottom Hinged Front and Back Covers
  Both the front and back covers fold open for easy access to all components.

• Air Filter
  Oversized air filter provided inside of front cover features a screw-on clear filter bowl for easy filter cleaning.

Specifications:

• Light-Duty Frame is rated up to 2200 lb (997.9 kg) and is designed for mounting on a 3” x 3” beam with 5/8-11 UNC hardware.

• Standard-Duty Frame is rated up to 6900 lb (3130 kg) and is designed for mounting on a 3” x 6” beam with 3/4-10 UNC hardware.

• Heavy-Duty Frames:
  · Frame H and HO type is rated up to 7000 lbs (3175 kg) Used for mounting on a 5” x 7” beam for 3/4-10 UNC hardware.
  · Frame HD and HDO type is rated up to 10,000 lbs (4536 kg) With reinforced lifting bale and for mounting on a 5” x 7” beam with 1”-8 UNC hardware.
  · Frame X type is rated up to 10,000 lbs (4536 kg) With reinforced lifting bale and for thru-beam mounting on a 6” x 8” beam for 1”-8 UNC hardware.

• Remote Mount Frame (no lift bale). Includes 14” x 8” mounting pattern for 3/8-16 hardware. • Vac-Packs are available for other voltages . Contact ANVER for information and application requirements.

Vacuum Pump*:

• Vacuum Pump is thermally overload protected and requires 115V/1PH/60Hz 15 amp service, oil-less dry piston pump has a 3/4 H.P. pump motor.

• Operating Temperature: 35°F to 135°F (1.7°C to 57.2°C)

Options:

• P/N: VLS-03AUX Auxiliary Alarm System
  Additional (2) sets of alarm light mounted on left and right side of vac-pack or mounted remotely on lifting structure and 107 dBA alarm horn. Contact ANVER for information and application requirements.

ANVER Corp.,  36 Parmenter Rd,  Hudson, MA  01749  USA  -  Tel: 800-654-3500  -  +1-978-568-0221  -  Fax: +1-978-568-1570

Copyright © ANVER Corp. 2012

Terms of use