Vacuum System Components JTSED-W Electronic Vacuum Switch with Digital Readout
The JTSED-W Electronic Vacuum Switch converts the vacuum level into digital output for connection to PLC systems as well as into analog output for the on/off control. The JTSED-W Electronic Vacuum Switch is identical to the JTSE Switch except for the addition of a digital LED display.
Input voltage: 10 – 24 V DC
Accuracy: ±3.0% F.S.
Part Number
Schematic
JTSED-W
The JTSED-W Digital Vacuum Switch mounts easily and conveniently under the nozzle and muffler of ANVER JB Series Vacuum Generators. The switch is provided with 4.9 ft (1.5m) of connection cable.
Specifications for JTSED-W Vacuum Switch
Media
Non-Corrosive gases and Non-Lubricated air
Power Supply
10.8 ~ 26.4 V DC, ripple (P-P) 10% max., Reverse Voltage Protection
1 Switch Output
N.C., max. 125 mA, LED indication on display, PNP version
Display
2 digit
Pressure Units
kPa
Hysteresis
± 0.5% F.S.
Electrical Connection
Grommet Lead Wire
Air Connection
M5 Female and G1/8″ Male – Standard
Operation Accuracy
± 3% F.S.
Thermal Error
± 3% F.S. in range 0 ~ 50°C (32 ~ 122°F)
Response Time
< 5 ms
Current Consumption
< 35 mA
Dielectric Strength
500 V AC 1 min
Insulation Resistance
> 100 M ohm at 500 V DC
Interference Emission
As Per DIN EN 50081-1
Immunity to Interference
As Per DIN EN 50082-2
Operating Temperature Range
0 ~ 60°C (32 ~ 140°F)
Storage Temperature Range
-10 ~ 70°C (14 ~ 158°F)
Operating Humidity Range
10 ~ 85 % RH
Vibration
10~55 Hz 1.5 mm (0.06″), XYZ, 2hrs
Mass
35 g (1.24 oz)
Weight
50 Grams
JTSED-W Electronic Vacuum
Switch with standard G1/8″
male connector
